INSTALLATION-continued

TM 9-2350-222-20-1-3

POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 18 of 23)

32.

Remove protective coverings from

hydraulic brake line openings.

NOTE

If your vehicle is equipped with the

hydraulic brake quick-disconnect,

proceed to step 33.1.

33.

Using 9/16 inch wrench, install brake

line (V).

WARNING

Dry cleaning solvent P-D-680 is toxic

and flammable. To avoid injury wear

protective goggles and gloves and use

in a well-ventilated area. Avoid contact

with skin, eyes, and clothes, and do not

breathe vapors. Do not use near open

fire or excessive heat. The flash point

for Type I dry cleaning solvent is 100°F

(38°C), and for Type II is 140°F (60°C). If

you become dizzy while using dry

cleaning

solvent,

get

fresh

air

immediately and get medical aid. If

contact with eyes is made, wash your

eyes with water and get medical aid

immediately.

33.1.

Using dry cleaning solvent, clean both

halves of quick-disconnect coupling (V.1).

Check spring action of movable collar (V.2) on

33.2.

female half of quick-disconnect coupling.

If action is not smooth, pour dry cleaning

solvent between collar (V.2) and inner element

and work collar (V.2) back and forth until free of

dirt and grime and action is smooth.

Using dry rags, dry both halves of quick-

33.3.

disconnect coupling.

Connect female half of quick-disconnect

33.4.

coupling to male half by twisting clockwise

until collar (V.2) snaps over locking nut (V.3). Be sure

collar (V.2) is securely locked down over locking nut (V.3).

Go on to Sheet 18.1

Change 4

5-42