INSTALLATION-continued

TM 9-2350-222-20-1-3

POWERPLANT REPLACEMENT (2D ENGINE) (Sheet 17 of 23)

23. Position rod end of parking brake control into

bellcrank (K).

24. Manually install straight pin (L).

25. Using pliers, install cotter pin (M).

26. Using 9/16 inch socket, install two screws (N)

and Iockwashers (P) to hold parking brake

support bracket.

27.

Position angle brackets (Q) to rear side walls

(by powerplant guides). Hang tab of brackets

onto tabs on compartment side walls.

28.

Manually start three screws (R), lockwashers

(S), and washers (T) to hold angle bracket (Q)

to side walls.

29.

Using 9/16 inch socket with 2 inch extension,

tighten three screws (R) to secure angle

brackets (Q) to side walls.

30.

Remove protective coverings from fuel return

line openings.

31.

Manually connect fuel return line by pulling

back on quick-disconnect fitting (U) and

inserting male connector into female

connector.

Go on to Sheet 18

5-41

Change 4