Section II. SERVICE UPON RECEIPT

TM 5-5420-22620-1 All data on page 3-5 deleted. Section II. SERVICE UPON RECEIPT GENERAL This section contains information on services to be performed upon receipt of the vehicle from the issuing organization. Where practicable, the crew will assist in the described services. For services to be performed on the launcher components, refer to TM 5-5420-227-24. INSPECTION AND SERVICING a. b. c. d. Inspect vehicle for damage. Check inventory components (with assistance of Check packing list against basic issue items list items have been received. Record all missing items. issuing organization) against packing list, (TM 5-5420-226-10) to insure that all indicated INSTALLATION AND SETUP a. b. c. d. Make sure that grade of engine oil installed, as indicated on processing tag (DD Form 1397), is of the grade specified by LO 5-5420-226-12 for temperatures in your area. Check oil level in engine and transmission, service as required (LO 5-5420-226-12). Start engine (TM 5-5420-226-10). Check for fuel and oil leaks. If leaks are observed, shut engine down and correct. Perform Preventive Maintenance Checks and Services, Subsection I, weekly (TM 5-5420-22610). inspection, check all parts and surrounding areas for corrosion. Corrosion Stage 1. Red, black, and white corrosion deposits metal is sound. Stage 2. Powdered, granular, or scaled condition. CORROSION INSPECTION a. During normal semiannual damage is divided into the following stages b. on surface, etching, and pitting. Base Base metal is sound. Stage 3. Surface condition and corrosion deposits are similar to Stage 2, except that metal in the corroded area is unsound and small pin holes may be present. Stage 4. No metal remains at point of severest corrosion. Corrosion holes in the area or metal is completely missing. Corrosion areas in Stages 1 and 2 shall be cleaned, primed, and painted with required final top coat in accordance with TM 43-0139. In areas where Stages 3 and 4 corrosion conditions exist, corrosion must be completely removed, repairs made, or parts/assemblies replaced with serviceable parts/assemblies where repair is not economical. (3.5 blank)/3-6 Change 5