|
| |
Back
ENGINE SMOKE GENERATING SYSTEM | Up
TM-5-5420-226-20-1 Medium Girder Bridge Incuding Bridge Set Bridge Erection Set Link Reinforcement Set Manual | Next
SUSPENSION |
TM 5-5420-226-20-1
CHAPTER 3
HULL MAINTENANCE
Section I.
REPAIR PARTS, SPECIAL TOOLS, TESTING, MEASURING,
DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special tools for organizational maintenance are listed and illustrated in TM 5-5420-226-24P, which is the
authority for requisitioning replacements.
ENGINE
Item
Use
1. Mechanical Puller
Remove fan drive oil seal housing
(5379997)
2. Sleeve Spacer
Prevent oil leakage from fan rotor
(10882651)
hub when performing leak check
(two required)
3. Open End Wrench
Remove and install starter mounting
(8761568)
nuts
4. Box and Open Wrench
Remove and install generator
(10935476)
mounting nuts
4.1. V-Pack Cleaner
Clean air cleaner filter
(12326132)
TRANSMISSION
Item
Use
5. Socket Wrench Socket
Loosen and tighten locknuts
(7003946)
on reverse band adjusting screw
and low range band adjusting screw
6. Deleted
Change 5 3-1
|
