Electrical Panel and BII Compartment and Tool and Battery Compartment

Electrical Panel and BII Compartment and Tool and Battery Compartment Electrical panel and BII compartment (1) is the left compartment at the rear of the machine. To gain access to the electrical panel and BII compartment, lift the bottom of rubber latches (4), and then rotate the top of the rubber latches away from the compartment. Use grab rail (3) to pull the lid towards the rear of the machine, and then raise the lid. Close electrical panel and BII compartment (1) by lowering the lid, rotating the top of rubber latches (4) towards the compartment, and then pushing the bottom of the rubber latches towards the compartment. The lid is secure when the top of the rubber latch clamps the lip which is attached to the lid. Tool and battery compartment (2) is the right compartment, at the rear of the machine. Two rubber latches (5) secure the lid of the compartment. Access to the tool battery compartment can be gained by following the same procedure as described for access to electrical panel and BII compartment (1). Emergency Brake Release Valve NOTE: The emergency brake release valve is used by Unit Maintenance personnel when they tow the machine. Radiator Shown in Raised Position for Photographic Clarity. Valve (1) is located on the multifunction valve in the air intake compartment, on the left side of the machine. Open—Turn valve (1) fully counterclockwise for normal operation. Closed—Turn valve (1) fully clockwise to prepare the machine for manual parking brake release. When valve (1) is closed, the drain passage from the parking brake is plugged, which allows the manual brake release pump to operate. 1 1 2 3 4 5 49 Operation Section Machine Features TM5-2430-200-10