Grab Rails

Grab Rails Six grab rails (1) are located around the rear of the machine. The grab rails should be in the up position whenever personnel are standing on the walkways. The grab rails should be in the down position when operating the machine in areas where tree branches and/or brush may damage the rails. To raise a grab rail, remove locking pins (2 and 3) from the bottom holes, and rotate the rail up. Replace the locking pins in top holes (4 and 5) to lock the grab rail in the up position. NOTE: The grab rails are pinned so they can be lowered for air transport. In the up position, some movement of the rails may occur. Engine Coolant Fill Cap At operating temperature, the engine coolant is hot and under pressure. Any contact with the skin can cause severe burns. Also, cooling system additive contains alkali. Avoid contact with the skin, eyes, and the mouth. Do not open engine coolant fill cap (3) until the temperature of the engine coolant is below 36°C (98°F). Raise radiator guard (1) to access engine coolant fill cap (3). Place support rod (2) in the prop hole in the radiator guard to secure the guard in the open position. Turn engine coolant fill cap (3) counterclockwise to remove it. Press in and rotate the cap clockwise to install it. NOTE: The normal location for checking the coolant level and adding coolant is the coolant overflow bottle. Only add coolant at this location if the coolant overflow bottle is empty or the cooling system has been completely drained. 3 2 3 1 WARNING ! 5 4 1 2 3 47 Operation Section Machine Features TM5-2430-200-10