42 TM5-2430-200-10 Operation Section Machine Features Remote Throttle Switch Do  not  activate  the  remote  throttle  switch  when  the vehicle is moving. When the remote throttle switch is put    in    the    ON    position,    the    parking    brake    is automatically  applied,  the  transmission  is  put  into NEUTRAL, and the accelerator pedal is disabled. The remote throttle system holds the engine at a   constant high speed for use when operating remote hydraulic tools. Lift switch cover  (1) to access switch. ON (2)—Move the switch into the ON position (up) to   set the engine speed at 2400 rpm. OFF (3)—Move switch cover (1) down to move the   switch into the OFF position. NOTE: If the remote throttle switch is moved into the   OFF position while the transmission control is NOT in NEUTRAL, the transmission will remain in NEUTRAL   until the shift lever is cycled back to the NEUTRAL position. If the parking brake switch is in the OFF position when the remote throttle switch is moved to the OFF position, the parking brake will remain ON   until the parking brake switch is cycled to the ON and   OFF positions. Kneeling Switch The kneeling switch lowers the front of the machine   for air transport. Refer to “Transportation Information, Preparation for Air Transport (C-130,C-141 , C-5)” in this section. Raise (1)—Hold the switch up in the RAISE position to fully extend the front suspension cylinders and raise the machine. NOTE: The blackout switch must be in the STOP   LIGHT or SERVICE DRIVE position for indicator (3) to function. _____________________________________________ NOTICE The  front  cylinder  locks  must  be  installed  to  secure  the machine in the kneeled position. Do  not  operate  the  machine  at  speeds  greater  than  3      kph (2 mph) while it is lowered. Only    operate    the    machine    in    the    RAISE    position,        unless in the air transport mode. _____________________________________________ Lower (2)—Hold the switch down in the LOWER position to fully retract the front suspension cylinders and lower the machine. indicator (3) turns on when the machine is fully lowered. NOTE: The kneeling switch is a three-position toggle switch. The center position of the switch is the OFF position. The switch is spring-centered to the OFF   position. NOTE: The machine will not kneel if it is in the EARTHMOVING mode, or if the manual suspension   lock valves are in the LOCK position.