26 TM5-2430-200-10 Operation Section Monitoring Systems and Cab Features Blade Down (3)—Indicates that the blade is   not in the full up position when the machine is in SELF-DEPLOY mode. NOTE: If the blackout switch is in the STOP LIGHT or SERVICE DRIVE position, the blade down alarm will sound when blade down indicator (3) is illuminated. Start-Aid (4)—Indicates the operation of the start-aid system (intake air heater or ether injection). NOTE: The blackout switch must be in the STOP   LIGHT or SERVICE DRIVE position for start-aid   indicator (4) to function. Engine Oil Pressure (5)—Indicates that there is not enough engine oil pressure. The oil pressure indicator illuminates when the oil pressure is 35 ± 21 kPa (5 ± 3 psi) NOTICE Do  not  continue  to  operate  the  machine  if  the  engine     oil pressure indicator is on, or if the engine oil pressure gauge indicates an engine oil pressure of less than 50 kPa (10 psi), 15 seconds after starting the engine. Stop the machine immediately and inform Unit  Maintenance of  the  problem.  Do  not  operate  the  machine  until  the cause    of    the    low    engine    oil    pressure    has    been corrected. Check Engine (6)—Indicates the presence of   a fault code in the engine electronic control module. Refer to “Troubleshooting, Engine Diagnostic Codes” in this manual for information on diagnostic codes. NOTE: The blackout switch must be in the stop LIGHT or SERVICE DRIVE position for check engine Indicator (6) to function. Crank-Without-Inject (7)—Indicates the fuel delivery System has been disabled, to allow the engine to be Turned over without starting. This operational mode is Used only by service personnel to repair the engine. NOTE: the blackout switch must be in the STOP   LIGHT or SERVICE DRIVE position for crane-without- Inject indicator (7) to function. Turn signal (8)—Indicates the direction of the turn signal. NOTE: The blackout switch must be in the STOP LIGHT or SERVICE DRIVE position for turn signal Indicators (8) to function. Kneeling (9)—Indicates that the machine is fully Lowered into the kneeling mode. NOTE: the blackout switch must be in the STOP LIGHT or SERVICE DRIVE position for kneeling mode Indicator (9) to function. Winch (10)—Indicates that the winch control system is activated. NOTE: The blackout switch must be in the STOP LIGHT or SERVICE DRIVE position for winch indicator (10) to function. Self-Deploy Mode (11)—Indicates that the suspension is active and the machine is in SELF- DEPLOY mode. NOTE: The blackout switch must be in the STOP LIGHT or SERVICE DRIVE position for self-deploy mode indicator (11) to function.