24      TM5-2430-200-10     Operation Section Monitoring Systems and Cab Features ·  Low Brake Pressure Indicator (43) ·  Blade Down Indicator (50) ·  Engine Oil Pressure Indicator (44) ·  Hydraulic Oil Temperature Indicator (54) ·  Start-Aid Indicator (55) ·  Check Engine Indicator (51) ·  Crank-Without-Inject Indicator (45) ·  Kneeling Mode Indicator (46) ·  Winch Indicator (47) ·  Self-Deploy Indicator (48, dim level) ·  Remote Throttle Indicator (53) SERVICE DRIVE (25), PARK (29)—Move lever (A)   into the SERVICE DRIVE position and lever (C) into the PARK position to enable the following lamps to   function: ·  Right and Left Brake Lamps (40) ·  Interior Light (56) ·  Right and Left Rear Working Lamps (19) ·  Right and Left Center Work Lamps (18) ·  Right and Left Front Work Lamps (18) ·  Right and Left Turn Lamps (42, on panel) ·  Rear Right and Left Turn Signal Lamps (37) ·  Front Right and Left Turn Signal Lamps (33) ·  Right and Left Tail Lamps (39) ·  Right and Left Front Marker Lamps (32) ·  All Panel and Gauge Lamps (52, dim level) ·  Tension Fail Indicator (49) ·  Low Brake Pressure Indicator (43) ·  Blade Down Indicator (50) ·  Engine Oil Pressure Indicator (44) ·  Hydraulic Oil Temperature Indicator (54) ·  Start-Aid Indicator (55) ·  Check Engine Indicator (51) ·  Crank-Without-Inject Indicator (45) ·  Kneeling Mode Indicator (46) ·  Winch Indicator (47) ·  Self-Deploy Indicator (48, dim level) Gauges Engine Oil Pressure (1)—Indicates the engine oil pressure is kPa (psi) NOTE: The normal engine oil pressure range should Be between 250 and 450 kPA (30 and 70 psi) when The engine is running at full speed with SAE 15W40 oil at operating temperature. Engine Coolant Temperature (2)—Indicates   the temperature of the engine coolant in degrees celsius and degrees fahrenheit. If the engine coolant temperature increases above 110°C (230°F), stop operation of the machine and allow the engine to idle for a few minutes. If the coolant   temperature will not return to 110°C (230°F) or less   during normal working conditions, stop the machine   and investigate the cause of engine overheating. Transmission Oil Temperature (3)—Indicates   the temperature of the transmission system oil in °C (°F). If the transmission system oil temperature increases above 110°C (230°F), stop operation of the machine and allow it to idle for a few minutes. If the transmission oil temperature will not   return to 110°C (230°F) or less during normal working conditions, stop the machine and investigate the   cause of the transmission system overheating. Engine RPM (4)—Indicates the engine speed in revolutions (Xl00) per minute. The service Hour Meter is located on the engine rpm gauge. Speedometer (5)—Indicates machine ground speed in miles-per-hour and kilometers-per-hour. Voltmeter (6)—Indicates the electrical system voltage at different operating conditions.