HYDRAULIC HOSE ASSEMBLY REPLACEMENT CONT.

TM 5-2350-262-20-2 Change 3 4-415 A Route hoses (1), (2) and (3) in appropriate locations for installation. B Install hoses (1) and (2) on elbows (14) and (15) at directional control valve bank (16). C Connect hoses (1) and (2) to elbows (4) and (5) at winch motor (7). D Connect hose (3) to elbow (5) at hydraulic motor and adapter (6) at bottom of hydraulic reservoir. INSTALLATION Note • Refer to hose and tube marker band identification (p 3-101) for specific hose routing. • Class III leaks can occur if hydraulic lines and fittings are improperly installed or not fully servicable. Refer to page 2-29 when replacing or repairing hydraulic system components. Always inspect suspension system lines, fittings, and packings for servicablity before installation. • Use two wrenches to connect hoses to fittings. E Secure hoses (1), (2) and (3) to bracket (11) with hose bracket (12), retain strap (13), washer (10), and new self-locking screw (9). F Secure hoses (1), (2) and (3) with tiedown straps (8). FOLLOW-ON TASKS: • Install rear floor plates (p 4-360). • Install hull access covers (p 4-375). • Service hydraulic tank (TM 5-2350-262-10). • Retract ejector (TM 5-2350-262-10). 16 14 15 13 12 11 10 9 4 7 5 2 1 8 3 6