TM  55-1520-240-23-9 11-13 REPAIR  FINISH OF BELLCRANK  AND  ARMS (Continued) 11-13 Do  not  remove  bellcrank  or arms from  aircraft  unless there  is  danger of solvents or solution  coming  in  contact with  other parts.  Do  not allow solvents to  contact  bearings.   Do  not  allow nitric  acid  (E22)  or  alodine  solution (E65)  to  contact  high  strength  steel part.  Failure  of  component  can  result. NOTE This procedure  is  for minor damage to  protective  coat. 1. Check if component is aluminum.  Place  a  drop  of 10 percent solution  of  sodium  hydroxide  (E358) on  bare  damaged  surface.  Rapid  reaction  should occur.   Wear gloves (E184.1). 2. Check  if  component  is  magnesium.   Place  a drop  of  10 percent solution  of  sodium  hydroxide (E358)  on  bare  damaged  surface.   No  rapid action  should  occur.  Wear gloves  (E184.1). MAGNESIUM  COMPONENTS 3. Repair magnesium  components with  epoxy  finish as  follows: a. Clean  damaged  surface.   Use  cloth  (E112) damp  with  naphtha  (E245).   Wear  gloves (E184.1). b. Scuff  damage  lightly  with  abrasive  paper (E9). c. Clean  damage.   Use  cloth  (E112) moist  with naphtha  (E245).  Wear gloves  (E184.1). d. Rinse  with  water, then  dry  using  heat gun. e. Mask damaged  area.  Use  tape  (E388). Do  not  add  water to  acids.   A violent action  will  result.  Avoid  contact  with skin.  Wear protective  clothing.  Wash thoroughly after using. f. Slowly  add  1-1/3 ounces  of  chromic acid (E114),  and  1  ounce  of  calcium  sulphate (E91) to  1 gallon  of water.  Water temperature should  be  between  70º to 90ºF (20º to 30ºC). Stir  vigorously for at least  15 minutes.  Use  a stainless steel,  aluminum, vinyl, polyethylene, or  rubber lined  container. g. Apply solution  from  step  d  to  damaged  area until  solution  turns  greenish-brown  or  brassy yellow.  Allow area  to  dry  for 30 minutes.  Use brush  to  apply  solution.   Mix  epoxy  primer (E293)  per manufacturer’s instructions.  Thin as  necessary.  Use  thinner (E145). h. Apply three  coats of epoxy  primer.  Allow  to air  dry  1 hour  between  coats. i. Apply two  coats  of  epoxy  topcoat  (E425). Mix per  instructions.  Thin  if  necessary.  Use thinner  (E415).   Allow  to  air  dry  1 hour between  coats. j. Remove  masking  tape. ALUMINUM  COMPONENTS 4. Repair aluminum  components with zinc chromate finish  as  follows: a. Clean  damaged  surface.   Use  cloth  (E112) damp  with  naphtha  (E245).   Wear  gloves (E184.1). b. Blend  damaged  surface.  Use  abrasive  paper (E9). c. Clean  surface.  Use  cloth  (E112) moist  with naphtha  (E245).  Wear gloves (E184.1).  Wipe dry. Do  not  add  water to  acids.   A  violent action  will  result.  Avoid  contact  with skin.  Wear protective  clothing.  Wash thoroughly after using. 11-51