TM  55-1520-240-23-9 11-12 REPAIR  CONTROL ARMS  AND  BELLCRANKS 11-12 INITIAL  SETUP Applicable  Configurations: All Tools: As  Required Materials: As  Required Personnel  Required: Medium  Helicopter Repairer Inspector References: TM  1-1500-204-23 Equipment  Condition: As  Required This  does  not  apply  to  bearing  or bushing  bores. 1. Damage  to  bores or holes must not be  more  than 0.015 inch in  depth  and  must not be  more  than 5 percent of  the  load  bearing  surface. 2. Remove  surface  scores,  tool  marks,  or corrosion pits  by  burnishing.   Depth  after  burnishing  must not  be  more  than  10  percent  of  thickness  or 0.040  inch,  whichever  is less.   An  area  of  20 times damage  depth  may  be  burnished.   If damage  is  close  to  fillets,  radii, holes, or edges, burnish  a  greater  area. 11-48