TM  55-1520-240-23-9 11-10 INSPECT FLIGHT CONTROL SYSTEM  BELLCRANKS AND IDLER  ARMS 11-10 INITIAL  SETUP Applicable Configurations: All Tools: As  Required Materials: None Personnel  Required: Inspector References: Task  11-8 Task  11-9 TM  1-1500-204-23 Equipment  Condition: As  Required NOTE Bellcranks  and  idler  arms  are made  from  2014-T6  aluminum  alloy, 7075-T73,  ZK60A-T5  magnesium alloy, or 4340  steel  forgings. Steel  bushings  (standard  and nonstandard)  are  installed  in  bolt holes  of  bellcranks  and  arms. MINOR DAMAGE 1. Inspect nicks,  scratches, scores,  corrosion  pits, or similar damage.  Depth of damage  must not be more  than  0.040  inch  or  10 percent of  material thickness, whichever is  less,  after  burnishing.  If damage  is more,  replace  part. 2. Burnish  around  filler,  radius, or bolt holes within limits  of step  1. BEARING  PLAY 3. If  component  is  installed  in  flight  control system, inspect bearings  for  play  (Task 11-9).  If component is  removed, inspect bearings for play (Task  11-8). FOLLOW-ON MAINTENANCE: As  Required END  OF  TASK 11-45