TM  55-1520-240-23-9 11-8 INSPECT BELLCRANK  AND  CONNECTING LINK BEARINGS (REMOVED) 11-8 INITIAL  SETUP Applicable  Configurations: All Tools: As  Required Materials: Cloths  (E120) Personnel  Required: Inspector References: TM  1-1500-204-23 TM  55-1500-322-24 Equipment  Condition: Off  Helicopter  Task Do  not  wash  bearing.   Solvent  will remove  lubricant  or  damage  dry-type bearings. ANTIFRICTION  TYPE BEARINGS 1. Check  antifriction  type  rod  end  bearings  as follows: a. Wipe  bearing  with  cloth  (E120). b. Rotate  lubricated  bearing.   Feel  for  rough spots,  binding  or  radial  looseness.   If  these defects  are  felt,  or  radial  looseness  is  more than  0.004  inch,  replace  bearing. NOTE Radial  looseness  more  than  0.004 inch may  be  felt  by  hand. Axial play  can  vary.  In  most  cases  this type  of  check  will  not  indicate  extent of  bearing  damage. 11-40