TM  55-1520-240-23-9 11-7 INSPECT  FLIGHT  CONTROL  SYSTEM  ALUMINUM  AND  STEEL  CONNECTING LINKS (Continued) 11-7 ADJUSTABLE  CONNECTING  LINKS NOTE Adjustable  connecting  links  are  made of  round  seamless  aluminum  alloy 2024-T4  or  steel  tubing  4130.   Rod end  fittings  are  swaged  or  riveted  on each  end. 6. Inspect  links  for  cracks.   There  shall  be  no cracks.   If  a  crack  is  suspected,  refer  to  TM 1-1520-253-23. 7. Inspect links  for  nicks  and  scratches.  Blend  out (Task  11-14). 8. Check that blended  area  is large  enough  to blend smoothly  with  next  undamaged  area. NOTE These  limits  apply  to  out-of-round damage  and  dents,  except for  tubes over  2  inches  diameter,  which must  not  be  more  than  0.015  inch out-of-round. 9. Check  link  for  dents.   Replace  link if  following limits  are  exceeded: a. Divide  tube  into  three  equal  lengths. b. Check for  dents  in  middle  one  third  of  tube. One  dent  is allowed.  Depth  of dent must  not be  more  than  0.010  inch.  Dent  must be  free of  nicks  and  scratches. c. Check for  dents in  outer  thirds of  tubes.  Total of  two  dents  is  allowed.   Depth  of dent  must not be  more  than  0.015 inch.  Dent  must  be free  of  nicks  and  scratches. 10. Check  link  for  out-of-round.   Replace  link  if following  limits  are  exceeded: a. For  tubes  less  than  2 inches  diameter, out-of-round  must not  be  more  than  0.010 inch in  middle  one  third  of  tube. b. For  tube  larger  than  2  inches  diameter, out-of-round  must not  be  more  than  0.015 inch in  middle  one  third  of  tube. c. For  any  diameter  tube,  out-of-round  must not be  more  than  0.015 inch  in  outer  third sections  of  tubes. 11-37