TM  55-1520-240-23-9 11-6.2.1 FLIGHT CONTROL  POWER-ON  LOOSENESS  CHECK 11-6.2.1 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Materials: None Personnel  Required: Medium  Helicopter Repairer  (2) References: Task  11-6.2 Equipment  Condition: Battery  Connected  (Task  1-39) Electrical  Power On Hydraulic Power  On 1. Check  dry-type  control  system  linkage  bearings for  excess  looseness  without  removing  the component  as  follows; Keep  head,  hands  and  other  body parts clear of moving  flight  controls. Hydraulic forces  are  strong  enough  to cause  severe  injury. a. Apply  hydraulic  boost  pressure  to  the  flight control  hydraulic  system. b. Open  all necessary covers for access to  the flight  controls. c. Move  cockpit  controls as required  to  position the  component  being  inspected  so  it  can  be moved  axially  between  its supports. d. Move  the  component  in  an  axial  direction  as far as  it will  go,  using  strong  hand  pressure. e. Measure  the  axial  distance  between  the component  and  the  support  ear or bellcrank lug. NOTE A  vernier  caliper or multi-leaf  feeler gage  is  a  satisfactory  tool  for measuring  this distance. f. Move  the  component  along  its  axis  in  the opposite  direction,  use  strong  hand  pressure. g. Measure  the  axial  distance  that  the component  moved  from  its position  in  step  e. h. If the  component  has  moved  in  excess  of 0.010  inch,  perform  Task  11-6.2,  Check Controls For Overall  Looseness. 11-25