TM  55-1520-240-23-9 11-6 CHECK SERVOCYLINDER CONTROL VALVE  FOR  FRICTION (Continued) 11-6 Do  not  disconnect  control  valve connecting  link.   Damage  to servocylinder  support  structure  or swashplate  can  result. NOTE Procedure  is  same  to  check forward or  aft  servocylinder  control  valves for  friction.   Check  of  forward  left servocylinder  control  valve  is  shown here. 1. Working  from  forward  left work platform,  attach scale  (1)  to  nut  (2) of  bolt  (3)  of  forward  left bellcrank  (4).  Use  twine  (E433). 2. Mount support (5) on  structure  (6).  Position  dial indicator  (7) on  top  surface  (8) of  bellcrank  (4) above  bolt (3).  Set indicator  at  mid-stroke. 3. Pull scale  (1)  up  until  indicator (7) starts to  read or scale  indicates 10 pounds.  If indicator reads, perform  step  4.  If  indicator does  not  read, check tunnel  controls for binding  (Task  11-6.1). INSPECT 4. Pull  scale  (1) down  until  indicator (7)  starts  to read  or  scale  indicates  10 pounds.  If indicator reads, perform  step  5.  If indicator does  not read, check  tunnel  controls for binding  (Task 11-6.1). INSPECT 5. Perform  control  valve  check on  forward  right and aft servocylinder valves. INSPECT FOLLOW-ON MAINTENANCE: Remove  hydraulic  power. Remove  electrical  power. Close  forward  and  aft  work  platforms (Task 2-2). END  OF  TASK 11-19