TM  55-1520-240-23-9 11-5 CHECK  CONTROLS  CLEARANCE 11-5 INITIAL  SETUP Applicable  Configurations: All Tools: As  Required Materials: As  Required Personnel  Required: Medium  Helicopter  Repairer Inspector References: TM  1-1500-204-23 Equipment  Condition: As  Required MINIMUM  CLEARANCE  CHECK 1. Check  flight  control  system  components  for minimum  clearances as  follows: a. Check  distance  between  moving  bellcranks and  structure,  cables,  piping,  or  mounted equipment.  Minimum  distance  shall  be  0.50 inch. b. Check  distance  between  moving  links  and bulkhead.   Minimum  distance  shall  be  0.20 inch. c. Check  distance  between  bellcrank  hubs and support  fittings  mounted  on  same  shaft. Minimum  distance  shall  be  0.03  inch. d. Check  distance  between  any  bellcrank arm  and  any  other  moving  part.   Minimum distance  shall  be  1 inch. 11-12