TM  55-1520-240-23-9 11-3 LUBRICATE FLIGHT CONTROL SYSTEM  ROD  END (ANTIFRICTION) 11-3 INITIAL  SETUP Applicable Configurations: All Tools: Grease  Gun  with  Nozzle  MS24203-1  or  Alemite Nozzle  314150 Materials: Grease  (E190) Personnel  Required: Medium  Helicopter Repairer Inspector References: TM  1-1500-204-23 Equipment  Condition: As  Required The  following  procedures  shall be  performed  carefully  due  to  the sensitivity  of  bearing  seals. NOTE The  rod  end  bearings  that  are located  in  the  pedal  box  area, flight cockpit controls, pilot cockpit controls assembly, and  copilot  cockpit  controls assembly are not exposed to the  same severe  conditions  as  the  bearings located  in  the  forward  pylon,  mixing complex,  tunnel  area,  aft  fuselage, and  aft  pylon.  The  pedal  box  bearings are  in  an  enclosed  protective  area and  would  be  difficult  to  lubricate  the bearings without removing  them  from the  aircraft; therefore,  there’s no  need to  lubricate  these  bearings  at  the same  schedule  as the  other  bearings. 1. Rod  end  bearings  located  in  the  pedal  box  area shall  be  lubricated  only when  the  pedal  boxes are  removed  from  the  aircraft for other reasons. 2. Rod  end  bearings  located  in  the  flight  control closet  area,  forward  pylon,  mixing  complex, tunnel  area,  aft  fuselage,  and  aft  pylon  shall be lubricated  every 1st  and  3rd  phase  inspection. 3. Lubricate  the flight control rod end  rolling element as  follows: a. Identify  and  locate  bearings  to  be re-lubricated. b. Prior to  lubrication,  ensure  that the  grease gun  and  nozzle  are  clean  and  free  of contamination. c. Fill  the  grease  gun  with  grease  (E190). d. It may  be  necessary  to  remove  some  flight control  links in  order  to  obtain  access to  the rod  end  bearing  grease  fitting. e. Clean  the  exterior of  the  bearing  using  a clean  cloth. NOTE Cleanliness  cannot  be  over emphasized  with  respect  to prolonging  bearing  life. f. Do  not  remove  bearing  from  rod  end component. During  application  of  grease,  take care  in  operating  the  grease  gun  so that you  do  not  over  pressurize  and damage  the  bearing  seals/shields. Operate  the  grease  gun  in  a  slow and smooth  technique  during  application. g. Using  grease  (E190) and  hand  operated grease  gun, attach  gun  and  pressurize. h. Allow  the  grease  to  flow  until  grease  that exudes out from  around  the  bearing  is clean. If possible,  the  bearing  should  be  rotated 360º  during  lubrication. 11-9