TM  55-1520-240-23-8 10-12 REPAIR  FUEL CELL EXTERIOR PLIES (Continued) 10-12 j. Carefully  apply  a  uniform  coat  of  repair cement  (E63.2)  over  patched  area  (4)  to  no more  than  1/8 inch  buffed  area  edge.  Use  a brush.   Smooth  surface  with  gloved  fingers wet  with  MEK  (E244)  and  remove  any  excess cement  from  unbuffed  area  with  a  clean cloth  (E120)  and  MEK  (E244).  Wear  gloves (E184.1). k. Allow  finished  repair  to  set  for  1  hour  before moving  fuel  cell. l. Allow  finished  repair  to  air  cure  for  24 hours before  use. INSPECT FOLLOW-ON  MAINTENANCE: Visually  inspect  repair  for  workmanship,  no  loose edges,  no  voids,  cement  fully  cured. Tasks  10-13  and  10-14  deleted. END  OF  TASK 10-56