TM  55-1520-240-23-8 10-12 REPAIR  FUEL  CELL  EXTERIOR  PLIES (Continued) 10-12 e. Prepare  repair cement  (E63.2)  by  blending the  two  ingredients of part 2  (E63.5) together first and  then  transfer the  entire  contents  of part 2  into  the  can  of  part  1  (E63.4).   Wear gloves  (E186). Unmixed  cement  will  not  cure. f. Stir  cement  mixture  with  tongue  depressor (E424)  for  approximately 5  minutes.  Make certain  components  are  completely blended together. g. Carefully  apply  a  uniform  coat  of  repair cement (4) to  no  more  than  1/4  inch  of  O.D. of  buffed  area  (5).   Use  a  brush.   Smooth surface  with  gloved  fingers  wet  with  MEK (E244)  and  remove  any excess cement  from unbuffed  area  with  a  clean  cloth  (E120) and MEK (E244).  Wear gloves  (E184.1). h. Wet  fabric reinforcement patch  (3)  with  MEK (E244).  Shake  out  excess  MEK. i. Center  wet  patch  (3)  over defect  area  and press into  wet  cement (6) with  gloved  fingers to  make  sure  patch  is free  of air  bubbles and loose  edges. 10-55