TM  55-1520-240-23-8 10-4 INSPECT FUEL TANK  ASSEMBLIES (Continued) 10-4 NOTE Procedure  is  same  to  inspect  left  or right  fuel  tank  assemblies.   Left  tanks are  shown  here. INSPECT MAIN  FUEL TANK 1. Check  interior  of  main  pod  (1).   There  shall be  no  damage,  layer  separation,  leakage,  or contamination. 2. Check  cell (2).  There  shall  be  no  damage,  layer separation,  no  fuel  in  self-sealing  layers,  and  no green,  sponge-like  material. 3. Check  interior  of  cell  (2).   Interior  shall  not  be contaminated  with  mold. 4. Check  exterior  surfaces  of  cell  (2).  Anti-chafing tape  shall  be  secure,  and  there  shall  be  no chafing  damage. 5. Check  hoses,  fittings,  and  tubing  inside  tank  (2). There  shall  be  no  damage  or  deterioration. 6. Check  vent  drain  lines  (3).   Lines  must  not  have high  or  low  spots  that  can  trap  fluid. 7. Check  probes  (4).   Hoses  and  tubing  must  not contact  probes  under  normal movement. INSPECT FORWARD  FUEL TANK 8. Check  interior  of  forward  pod  (5).   There  shall be  no  damage,  layer  separation,  leakage,  or contamination. 9. Check  cell (6).  There  shall  be  no  damage,  layer separation,  no  fuel  in  self-sealing  layers,  and  no green,  sponge-like  material. 10. Check  interior  of  cell  (6).   Interior  shall  not  be contaminated  with  mold. 11. Check  exterior  surface  of  cell  (6).   Anti-chafing tape  (E381)  shall  be  secure,  and  there  shall be no  chafing  damage. 12. Check  hoses,  fittings,  and  tubing  inside  cell  (6). There  shall  be  no  damage  or  deterioration. 13. Check  vent  drain  lines  (7).   Lines  must  not  have high  or  low  spots  that  can  trap  fluid. 10-32