TM  55-1520-240-23-8 10-3 PURGING OF FUEL TANK  WITH  AIR 10-3 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Air  Supply,  80  to  120  Lbs.   Per  Sq.   In. Lamb  Air  Remover  (T-200) Combustible  Gas  Indicator  (T-219) Grounded  Air  Blower  (or  Equivalent) Materials: Tape  (E388) Personnel  Required: Medium  Helicopter  Repairer References: Task  2-2 Task  10-51 Task  10-53 Task  10-69 Task  10-79 Equipment  Condition: Battery  Disconnected  (Task  1-39) Electrical  Power  Off Helicopter  Grounded  (Task  1-29) Fuel  Tank  Defueled  (Task  10-34  or  10-35) Two  Tank  Drain  Valves  Removed  (Task  10-39) General Safety Instructions: All  regulations  and  instructions on  handling  fuels  shall  be  strictly observed. NOTE Air  purging  forces  fresh  air  into  the defueled  tank  to  replace  fuel vapors. Procedure  is  same  to  purge  any  fuel tank.   No.   1  (left)  main  fuel  tank purging  is  shown  here. 1. Connect  air  supply  hose  (1)  to  air  mover  (2). 2. Open  air  supply  valve  (3)  slowly. 3. Allow  air  supply  to  flow  to  clear  hose  (1)  and  air mover  (2). 4. Close  air  supply  valve  (3). 10-27