TM  55-1520-240-23-7 8-20 REMOVE  ENGINE  TORQUEMETER  POWER  SUPPLY 8-20 INITIAL  SETUP Applicable  Configurations: Without    74 Tools: Aircraft Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Workstand Materials: Cloths  (E120) Personnel  Required: Medium  Helicopter  Repairer  (2) Equipment  Condition: Battery Disconnected  (Task  1-39) Hydraulic  Power  Off Electrical  Power  Off Nose  Enclosure  Door  Open  (Task  2-2) NOTE Procedure  is  same  for  left  and  right power  supply.   Left power  supply  is shown  here. 1. Place  cloths (E120)  on  lower  windshield  panel to  protect  surface. 2. Remove  four  screws  (1)  and  washers (2). 3. Disconnect  cable  plug  (3). NOTE Power  supply will  not  pass  through nose  enclosure.   Vibration  absorber blocks  way. 4. Have  helper  remove  power  supply  (4)  through cockpit. FOLLOW-ON  MAINTENANCE: None END  OF  TASK 8-64