TM  55-1520-240-23-7 8-13 INSTALL NO. 2  GAS PRODUCER TACHOMETER GENERATOR (Continued) 8-13 3. Position  tachometer generator  (4)  on  mount pad  studs (2)  with  receptacle  (5)  positioned  at 2  o’clock. 4. Install  two  washers  (6)  and  nuts  (7)  on  two outboard  studs  (2).   Do  not  tighten  nuts  at  this time. 5. Position  bracket  (8)  over two  inboard  studs  (2). 6. Install  two  washers  (6)  and  nuts  (7)  on  two inboard  studs (2).  Tighten  all  four nuts (7). NOTE Check  that  packing  on  fitting  is servicable. 7. Install  fuel  control  fitting  (9). 8. Remove  cap  and  connect  oil  scavenge  hose  (10) to  dual  chip  detector  housing  fitting  (11). 9. Connect  drain  hose  (12). 10. Connect  drain  hose  (13). 11. Connect  drain  hose  (14). 12. Connect  drain  hose  (15). 13. Connect  clamp  (16)  to  bracket  (8).  Install  screw (17),  two  washers (18),  and  nut (19). 8-40