TM  55-1520-240-23-7 8-6 REMOVE  EMERGENCY  POWER  SWITCHES 8-6 INITIAL  SETUP Applicable Configurations: Without    74 Tools: Electrical  Repairer’s Tool Kit, NSN 5180-00-323-4915 Workstand Materials: Paper  Tags  (E264) Personnel  Required: Aircraft  Electrician Equipment  Condition: Battery Disconnected  (Task  1-39) Hydraulic  Power Off Electrical  Power Off Nose  Enclosure  Door  Open  (Task  2-2) NOTE Procedure  is the  same  for removing No.   1  or No.   2  engine  emergency power switches.  No.  1  is  shown  here. 1. Remove  nut (1) and  washer (2) from  switch  (3). 2. Push  switch  (3) up  and  out of bracket (4). 3. Remove  locking  ring  (5). 4. Pull switch  (3) down  into  area  between  frame  (6) and  absorber  (7). 5. Tag  two  wires  (8). 6. Remove  two  screws  (9)  and  two  washers (10). 7. Remove  two  wires  (8). FOLLOW-ON MAINTENANCE: None END  OF  TASK 8-25