TM  55-1520-240-23-7 8-4 INSTALL  PILOT’S  OR  COPILOT’S  EMERGENCY  POWER  LIGHT 8-4 INITIAL  SETUP Applicable  Configurations: Without   74 Tools: Electrical  Repairer’s Tool  Kit, NSN 5180-00-323-4915 Soldering  Gun Heat  Gun Materials: Solder (E360) Tubing  (E431) Personnel  Required: Aircraft  Electrician Inspector References: TM  55-1520-240-23P TM  55-1500-323-25 Remove  lens  and  lamp  prior  to soldering.   Lamp  center  contact  may melt  and  solder  in  place. NOTE Procedure  is the  same  to  install  pilot’s or copilot’s light.  Pilot’s is shown  here. 1. Remove  lens (1) and  lamp (2) from light base  (3). 2. Install tubing  (4) and solder wires (5) to  light base (3).  Slide  tubing  over solder joint and  shrink  with heat  gun  (TM  55-1500-323-25). 3. Install  light base  (3) in  panel mount hole  (6). 8-22