TM  55-1520-240-23-6 7-8.1 SAMPLE  HYDRAULIC  FLUID  FROM  FLIGHT CONTROL  AND  UTILITY  SYSTEM RESERVOIR/COOLERS (Continued) 7-8.1 Samples  must be  taken  directly  after system  has  been  operating  for  at least 15  minutes.  OtherwIse, sample may  not be  reliable  and  component malfunction  can  occur. 1. Loosen  clamp  (1)  on  hose  (2).   Disconnect hose  from  bleed  relief  valve  (3)  of  utility reservoir/cooler  (4). 2. Connect  sampling  tube  (5)  to  valve  (3).   Install clamp  (6)  on  tube. 3. Place  container (7) under tube  (5) open  end. 4. Remove  cap  (8) from  sample  bottle  (9).   Place cap  upside  down  on  clean  surface. 5. Turn  lever  (10)  to  open  valve  (3).   Bleed approximately  1 pint  of  fluid  into  container  (7), then  place  bottle  (9) under  tube  (5) open  end. Fill  to  within  1/2  inch  of  bottle  top.  Wear gloves (E186). 6. Close  valve  (3). 7. Install  cap  (8)  on  bottle  (9).   Wipe  bottle.   Use cloths  (E135). 8. Record  sampling  data.  (Refer to  TB  43-0106.) 9. Remove  clamp  (6)  from  tube  (5).   Disconnect tube  from  valve  (3).  Use  cloths  (E135)  for  spilled fluid. 10. Connect  hose  (2) to  valve  (3).  Tighten  clamp  (1). 11. Repeat steps  1  thru  10  for No.  1  and  No.  2  flight control  reservoir/cooler. INSPECT FOLLOW-ON MAINTENANCE: Close  right and  left  pylon  access panels (Task  2-2). Close  right  forward  work platform  (Task  2-2). Service  reservoir/coolers  (Tasks  1-50,  1-59,  1-60, and  1-61). END  OF  TASK 7-57