TM  55-1520-240-23-6 7-8.1 SAMPLE  HYDRAULIC  FLUID  FROM  FLIGHT CONTROL AND  UTILITY  SYSTEM RESERVOIR/COOLERS 7-8.1 INITIAL  SETUP Applicable  Configurations: All Tools: Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891 Sampling  Bottle  (3) (Refer  to  TB  43-0106) Sampling  Tube  (3) (Refer to  TB 43-0106) Container,  2  Quart Workstand Materials: Cloths  (E135) Gloves  (E186) Personnel  Required: Army  Aviator (2) Aircraft  Pneudraulics  Repairer Inspector References: TB  43-0106 Equipment  Condition: Perform  15  Minute  Ground  Run  (TM 55-1520-240-10) Battery Disconnected  (Task  1-39) Electrical  Power  Off Hydraulic  Power Off Right and  Left Pylon  Access Panel  Open  (Task 2-2) Right  Forward  Work Platform  Open  (Task  2-2) General Safety Instructions: Hydraulic fluid  (E199)  is toxic.   It  can irritate  skin  and  cause  burns.   Avoid inhaling.   Use  only  with  adequate ventilation.  Avoid  contact  with  skin, eyes,  or  clothing.  In  case  of contact, immediately  flush  skin  or eyes  with water  for  at  least 15 minutes.   Get medical  attention  for eyes. Hydraulic fluid  ejected  under pressure can  cause  injury  to  personnel. Hydraulic fluid  sprayed  into  the  air  is a  fire  hazard. 7-56