TM  55-1520-240-23-6 7-7 HYDRAULIC SYSTEMS  LEAKAGE GENERAL INFORMATION (Continued) 7-7 Task 7-283.5 TEST CARGO  DOOR PRESSURE ACTUATED  VALVE. Task  7-288  TEST  CARGO  DOOR  ACTUATOR MOTOR  (AVIM). Task  7-313  TEST  SWIVEL  LOCK  ACTUATOR (AVIM). NOTE Due  to  allowable  static and  dynamic leakage  of  pivoting  and  swiveling actuators  (145H6600  and  145H6700 series),  hydraulic  fluid  may  leak from  the  input  shaft  rubber  boot (145HS003)  during  actuator operation.   The  allowable  static leakage  for  actuator  control  valve assemblies  is 2  drops  per  minute per actuator.  The  allowable  dynamic leakage  for  actuator  control  valve assemblies is  4 drops  per 25 cycles per actuator.   One  cycle  equals one full  extension  and  retraction  of  the actuator. A  combination  of dynamic  leakage during  operation  and  static leakage may  cause  hydraulic  fluid  to  leak from  the  rubber  boot  around  the input  shaft  housing.   This  condition alone  is  not  cause  for replacing  an actuating  cylinder.   See  Task 7-123.2 for leakage  criteria. FOLLOW-ON MAINTENANCE: As  Required NO  BREAK  -  WORK  HARDER NO  BREAK  -  WORK  HARDER END  OF  TASK 7-53