TM  55-1520-240-23-6 7-6 REPLACE  ROSAN  ADAPTERS AND REDUCERS (Continued) 7-6 NOTE Adapter  lockring  (1)  may be  installed using  combination  wrench  and  drive tool  (step  30)  or  lockring  drive  tool (step  31). 30. Install  adapter lockring  (1)  while  zinc  chromate primer is  still  wet  as  follows: a. Select  proper combination  wrench  and  drive tool  RF98-DW  from  table  1. b. Rotate  combination  wrench  and  drive  tool onto  fitting  (6) until  it  touches  lockring  (1). Turn  the  tool until  it bottoms on  port (8). Any  sudden  increase  in  torque  will indicate  that lockring  serrations  and port serrations  are  not aligned. c. Torque  fitting  (6)  per  table  2.   If  serrations (9) cannot  be  aligned,  remove  combination wrench  and  drive  tool.   Lift  lockring  (1). Repeat  step  29. 31. Install  adapter lockring  (1)  while  zinc  chromate primer is  still  wet  as  follows: a. Select  RF69-TW series wrench  from  table  1. b. Place  wrench  over  fitting  (6).   It is  properly located  when  it  rests  on  lockring  (1). c. Select  lockring  drive  tool  RF98-DK  from table 1.   Set lockring  (1).   Use  a  hammer,  arbor press,  or  hydraulic  press. 32. Check  component for fluid  leaks before  installing on  helicopter. FOLLOW-ON MAINTENANCE: None END  OF  TASK 7-51