TM  55-1520-240-23-6 7-5 REPAIR  PERMASWAGE  PLUMBING (Continued) 7-5 SWAGE  TUBE 21. Mark  tube  ends.   Use  correct  marking  tool  for size  of  tube  to  be  swaged.   When  marking  with tool  D9862,  place  lip  stop  against  end  of tube as shown.  Using  the  slot  as  a  guide,  mark the tube  in  two  places 180º apart with  marking  pen (E271.2).   If  marking  tool  D9862  and  marking pen  (E271.2)  are  not available, see  table  for  tube insertion  band. 22. Position  prepared  tube  within  fitting.  Align  mating ends and  position  union  fitting.  Check  to  see  if swaging  at  separable  fitting  can  be  done  with  it installed  on  the  component.  If  not,  mark  fitting and  tube  so  that  proper  clocking  is obtained. Swage  fitting  off aircraft  as  follows: 7-36