TM  55-1520-240-23-6 7-5 REPAIR  PERMASWAGE  PLUMBING (Continued) 7-5 11. Lightly  lubricate  plug  (1)  with  hydraulic  fluid (E199). 12. Press in  plunger  (2).  Carefully  insert  tool  into  the tube  (3)  until cutter  (4)  is approximately 1/8 inch away from  burr.  Release  plunger  to  allow  plug  to expand  and  seal  tube. 13. Rotate  knurled  body  (5)  of  deburring  tool clockwise  while  applying  slight  pressure  to cutter  (1).  Continue  to  rotate  until  cutter  rotates smoothly,  indicating  tube  end  is deburred.  Do  not cut  too  deep  into  wall of tube.  Width  of deburring chamfer  shall  not  exceed  1/2 wall  thickness  of tube. 14. Without  depressing  plunger, pull  tool  from  tube (3)  until  first  bulge  of  plug  (1)  is  exposed.  Wipe off tube  and  plug.   Inspect  tube  end  for  proper deburring.  Repeat  step  13, if  needed. 15. Remove  deburring  tool  from  tube  (3).  Clean  all chips  from  tube  and  tool. 7-33