TM  55-1520-240-23-6 7-4.2 TUBE  BENDING  (AVIM) (Continued) 7-4.2 3. Make  sure  base  (2)  of  tube  bending  set  is securely  mounted  on  work  bench. 4. Install  correct  radius  collar  (3)  for  desired  bend radius of tube  (1)  on  holding  pins (4). 5. Position  correct  clamp  block  (5)  for  diameter of  tube  (1)  on  quick-lok  clamp  (6).   Install  two screws (7).  Make  sure  radius groove  (8)  in  clamp block  aligns with  radius groove  (9)  in  collar  (3). 6. Install  quick-lok  clamp  (6)  with  two  bolts  (10), washers  (11),  and  nuts  (12). 7. Adjust quick-lok  clamp  (6)  with  back-up  screw (12.1)  so  moderate  force  is  required  to  push  lock handle  (13)  over  center  to  lock  it.   Use  spacer rods  (13.1)  as necessary. 8. Position  tube  (1)  between  collar  (3)  and  clamp block  (5)  with  bend  line  (1.1)  against  clamp  block and  degree  line  (1.3)  at  top  of tube. 9. Position  follow-block  (14)  against  tube  (1)  and butted  against  clamp  block  (5). 7-24