TM  55-1520-240-23-6 7-4.2 TUBE  BENDING  (AVIM) (Continued) 7-4.2 Tube  ends  shall  be  square  to  tube centerline.  OD  of  tube  shall  be  free of  scratches  1-1/2 inches  from  tube ends  to  ensure  leak-proof swage  at end  fittings. NOTE If desired,  tube  may  be  cut oversize and  trimmed  to  desired  length  after bending. 1. Cut  tube  (1) to  required  length  (APP  E-50, chart A)  (Task 7-5).  If  tube  is cut  oversize, mark  both ends  of  tube  to  finished  length.   Use  marking pencil  (E271). 2. Mark  tube  (1) for  the  number  of  bends  to  be made  as  follows  (APP  E-50, Chart B): a. Identify  one  end  of  the  tube  as  the  X-end. Mark  distance  from  finished  X-end  to  each bend  with  a  line  (1.1) around  the  tube. b. Mark  a  reference  line  (1.2) about  2 inches long,  along  the  length  of  the  tube  at  the X-end.   Sight  down  the  length  of  the  tube from  the  X-end  with  the  reference  line  facing up  (12 o’clock). c. At  each  bendline  (1.1)  rotate  the  tube clockwise  the  number of degrees shown  in the  DIAL  C SET  column.   Make  a  reference line  (1.3) about  2  inches  long,  along  the length  of  the  tube  at the  bend  line. NOTE Use  the  line  at  the  X-end  as the  zero degree  reference  for tube  rotation  at each  bend  line. 7-23