TM  55-1520-240-23-6 7-4 INSTALL HYDRAULIC SYSTEM  PLUMBING (GENERAL INFORMATION) 7-4 INITIAL  SETUP Applicable  Configurations: All Tools: Hydraulic Repairer’s Tool Kit, NSN  5180-00-323-4891 Inspector’s  Tool  Kit, NSN  5180-00-323-5114 Containers Low  Pressure  Compressed  Air  Source Materials: Cloths  (E120) Hydraulic  Fluid  (E199) Teflon  Tape  (E398) Parts: Packings Seals Gaskets Personnel  Required: Aircraft  Pneudraulics  Repairer Inspector References: Task  1-13 TM  1-1500-204-23 NOTE When  installing  hydraulic  fittings, hoses  or  tubes,  use  following information  as  a  guide. INSTALLATION  OF  FITTINGS 1. Place  containers  and  cloths (E120)  to  catch  and absorb  fluid  that drains during  installation. 2. Clear  fittings with  low  pressure  compressed  air. 3. Inspect  threads for  burrs  or  stripping. 4. Coat all seals,  packings,  and  threads with  clean hydraulic  fluid  (E199). 5. Install  all  new  packings,  seals, or  gaskets. 6. Align  fittings  with  lines  before  final  tightening. INSTALLATION  OF  HOSES 7. Place  containers  and  cloths (E120)  to  catch  and absorb  fluid  that drains during  installation. 8. Clear  hoses with  low  pressure  compressed  air. 9. Inspect  threads for  burrs  or  stripping. 10. Inspect that hoses  are  not  frayed,  cut, worn,  or weather-cracked. Straightening  a  bend  in  a  used  hose may  damage  hose. NOTE Do  not  try to  straighten  bends in  hose. Use  hose  so  bends fit  location  (TM 1-1500-204-23). 11. Deleted. 12. Make  sure  hoses do  not  twist  when  tightening end  fittings or  nuts. 13. Make  sure  hose  is  free  to  follow  movement  of components.  Make  sure  hose  has no  bends  that restrict  fluid  flow. 14. Spiral  wrap  all  areas  on  hoses where  chafing  can occur.   Use  Teflon  tape  (E398). 15. Make  sure  hoses  are  properly  anchored  to prevent  chafing. 16. Torque  hose  end  fittings (Task  1-13). 7-18