TM  55-1520-240-23-6 7-2 INSPECT HYDRAULIC SYSTEM  PLUMBING (GENERAL INFORMATION) 7-2 INITIAL  SETUP Applicable Configurations: All Tools: Hydraulic  Repairer’s Tool  Kit, NSN 5180-00-323-4891 Inspector’s Tool  Kit, NSN 5180-00-323-5114 Personnel  Required: Aircraft  Pneudraulics  Repairer Inspector References: Task  7-3 Task  7-5 TM  1-1500-204-23 Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Hydraulic Power  Off Access  Panels  and  Work  Platforms  Open,  As Required  (Task  2-2) 1. Refer to  TM 1-1500-204-23  for wear and  damage limits  on  tubes,  hoses,  and  fittings. 2. Inspect for chafed, cracked,  dented, nicked,  and scored  tubes.  Replace  damaged  or  worn  tubing (Tasks  7-3  and  7-5). 3. Inspect rubber  fairleads, especially in  drive  shaft tunnel  area  and  under combining  transmission. Inspect for security,  wear  and  cracks  which  can cause  chafed  and  cracked  tubing.   Replace cracked  or  worn  fairleads.   Replace  worn, cracked  or chafed  tubing  (Tasks 7-3  and  7-5). 4. Inspect for  loose,  broken,  and  cracked  clamps. Replace  damaged  clamps. 5. Inspect for chafed, deteriorated, cut,  frayed, and cracked  hoses.  Replace  damaged  or worn  hoses (Tasks  7-3  and  7-5). 6. When  plumbing  is  disconnected,  inspect  fittings for  crossed,  burred,  and  stripped  threads. Replace  as necessary (Tasks 7-3  and  7-5).  Cap or plug  all  disconnected  fittings. FOLLOW-ON MAINTENANCE: Closed  access  panels  and  work  platforms,  as required  (Task  2-2). END  OF  TASK 7-15