TM  55-1520-240-23-5 6-20 ALIGN  FORWARD DRIVE  SHAFTING (Continued) 6-20 3. Check  position  of  mount (9)  on  bushing  (10) on either  side  between  No.   3  drive  shaft  (11) and No.  4  drive  shaft  (12).  Mount  shall  be  centered on  bushing  so  that  dimension  A  is  within  ±0.06 inch of dimension  B.  Move  entire  drive  shafting assembly  (13)  forward  or  aft  as  needed  to position  mount. FLIGHT  SAFETY PARTS These  are  installation  critical  flight safety  parts.   All  aspects  of  their assembly  and  installation  must  be ensured. Ensure  dimension  ‘C’  is  measured and  dimension  ‘D’  is  calculated  from dimension  ‘C’  and  recorded. Ensure  threaded  ring  (15) is  installed on  retainer  (16)  at  a  distance  of dimension  ‘D’  from  end  of retainer. NOTE Not  installing  threaded  ring  (15)  on retainer (16)  will  allow  forward  drive shafting  to  float  excessively.   This could  result  in  increased  loading  of aircraft  components. 4. Measure  distance  between  aft  end  of  adapter assembly (1) and  forward  face  of shoulder (14) on  combining  transmission  output  shaft (2).  Use a  steel rule.  Record  measurement as dimension C. 5. Subtract dimension  C of step  4  from 3.00 inches. Record  this  measurement  as  dimension  D. Adjust threaded  ring  (15) so  that distance  from the  end  of  retainer (16)  to  ring  face  (17)  equals dimension  D. 6. Install  retaining  ring  (18). 6-62