TM  55-1520-240-23-5 6-18 INSTALL NO.  2 THRU  NO.  6 FORWARD DRIVE  SHAFT (Continued) 6-18 NOTE Install  shaft No.  2  thru  No.  6  in  same way.  Typical shaft shown  here. INSTALL SHAFT Do  not allow bolt  to  turn.  If  bolt turns, bolt and  plates  can  be  damaged. 1. If  a  replacement  shaft  (1)  is  being  installed, remove  one  nut (2),  washer (3), and  bolt (4) from adapter assembly  (5).  During  removal, hold  head of bolt  with  wrench.  Install  bushing  (6) on  mount (7)  at  each  side  of  support  housing  (8). 2. Turn  bearing  support  housing  (8) so  that grease fitting  (9)  faces  up. NOTE Do  not  disturb  alignment of installed shafts.   This  keeps  forward  and  aft rotor  blades  in  phase. 3. With  aid  of  helper,  position  shaft  (1)  between installed  shafts  (10  and  11).   with  two  mount bushings  (6)  in  brackets  (12). 4. Coat  thread  of  six  bolts  (13)  with  oil  (E254). Install  three  bolts,  head  forward,  and  special washers  (14) at each  end  of shaft  (1). 6-55