TM  55-1520-240-23-5 6-17 INSTALL NO. 1  DRIVE  SHAFT 6-17 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN  5180-00-323-4692 Torque  Wrench,  100  to  150  Inch-Pounds Torque  Wrench,  700  to  1600  Inch-Pounds Materials: Oil  (E254) Personnel  Required: Medium  Helicopter  Repairer  (2) Inspector References: TM  55-1520-240-23P General Safety Instructions: Oil  (E254)  is  toxic.  It can  irritate  skin and  cause  burns.  Avoid  inhaling.  Use only with  adequate  ventilation.  Avoid contact  with  skin,  eyes,  or  clothing. In  case  of contact,  immediately  flush skin  or  eyes  for  at least 15 minutes. Get medical  attention  for  eyes. Do  not allow  bolt  to  turn.  If  bolt turns, bolt and  plates  can  be  damaged. 1. If  a  replacement  shaft  (1)  is  being  installed, remove  one  nut (2),  washer  (3), and  bolt (4)  from adapter  assembly  (5).  During  removal, hold  head of bolt  with  wrench.  Install  bushing  (6)  on  mount (7)  at  each  side  of  adapter  assembly. 2. Turn  bearing  support  housing  (8)  so  that grease fitting  (9)  faces  up. Check  to  insure  the  correct  part number  drive  shaft is  installed. 6-51