TM  55-1520-240-23-5 6-16 ASSEMBLE  DRIVE  SHAFT 6-16 INITIAL  SETUP Applicable  Configurations: All Tools: Powertrain  Tool  Kit,  NSN  5280-00-323-5267 Torque  Wrench,  30  to  150  Inch-Pounds Torque  Wrench,  700  to  1600  Inch-Pounds Aluminum  Tube,  3  Inch  ID,  1/8  Inch  Thick  Wall,  1  to 6  Inches  Long Arbor  Press Materials: Grease  (E190) Antiseize  Compound  (E75) Cloths  (E120) Parts: Cotter  Pin Personnel  Required: Aircraft  Powertrain  Repairer Inspector References: TM  55-1520-240-23P NOTE Assembly procedure  is  for  No.  1  thru No.  6  and  No.  8  drive  shafts.  Typical shaft  shown  here. 1. Pack  bearing  (1)  with  grease  (E190). 2. Install  bearing  (1) in  bearing  support  (2).   Use aluminum  tube  as  a  tool.   Make  sure  bearing seats  firmly  in  support. 3. Install  bearing  retainer  (3)  on  six  studs  (4) of bearing  support  (2).   Smooth  side  of  retainer shall  face  out. 4. Install  six  washers (5) and  nuts (6).  Torque  nuts to  60 inch-pounds.  Check  studs (4).  There  shall be  0.15 to 0.18 inch  of  stud  extending  through nut. 5. Position  mount  (7) on  each  side  of support (2). Install  bolt (8),  two  washers  (9), thin  washer (10) and  nut  (11) two  places  on  each  mount.  Torque nuts to  35  inch-pounds. 6. Check bolts (8).  There  shall be  0.06 to 0.16 inch of bolt  extending  through  each  nut  (11). 6-48