TM  55-1520-240-23-5 6-15 INSTALL FORWARD  DRIVE  SHAFT MOUNT (Continued) 6-15 7. Rotate  plates (4)  to  align  hole  (5) with  lower  of two  mounting  bolt  holes  in  support  (10). NOTE Reach  lower  bolt  holes  in  mount through  bolt hole  in  plates.  Use socket and  extension. 8. Install  two  bolts (11),  four washers (12),  two  thin washers  (13),  and  two  nuts  (14)  through  mount (2)  and  upper and  lower supports  (10).   Install bolts with  head  aft.  Install  thin  washer  between support  and  mount.   Torque  bolts to  30  to  35 inch-pounds. 9. Check  bolts (11).   There  shall  be  0.06 to 0.16 inch of  bolt  threads extending  through  nut  (14). Install  another washer (12)  or  a  thinner  washer (13) if  needed. 10. Remove  cloths  or  barrier material  (15) from under  shaft  (16). 11. Rotate  plates  (4) to  position  hole  (5)  on  top. 12. Coat  thread  of  bolt  (17)  with  oil  (E254).   Install bolt  (head  forward) and  special  washer  (18) through  plates  (4). 13. Install  washer (19)  and  nut (20). Do not allow bolt to  turn  when torquing nuts.  If bolt  turns,  it  can  damage  bolt and  plates. 14. Hold  head  of  bolt  (17)  with  wrench.  Check  nut (20) for friction  torque of at least 24 inch-pounds. If  nut  does  not meet  torque,  replace  it. 15. Torque  nuts  (20) to  1000 to 1100 inch-pounds. INSPECT FOLLOW-ON MAINTENANCE: Close  forward  drive  shaft  tunnel  access  doors  (Task 2-2). Install forward  transmission  fairing  (if removed) (Task 2-67). Perform  vibration  check  (TM  1-6625-724-13&P). END  OF  TASK 6-47