TM  55-1520-240-23-5 6-15 INSTALL  FORWARD  DRIVE  SHAFT MOUNT (Continued) 6-15 NOTE Install  left  or  right  mount  at  any  of six  places  in  same  way.  Typical  right mount  is  shown  here. 1. Install  bushing  (1)  in  mount  (2). NOTE There  are  two  types  of  mount  and bushing  assemblies used.  Helicopters with    1    and  those  modified  by attrition  have  improved  mount  and bushing  assemblies.  Be  sure  to  install matching  part  number  mounts  and bushings  on  both  sides of shaft. 2. Position  mount  (2) with  bushing  (1),  into  bracket (3). 3. Rotate  plates  (4)  to  align  bolt  hole  (5)  with bushing  (1). NOTE Reach  center  bolt  hole  in  mount through bolt holes in  plate.  Use  socket and  extension. 4. Coat thread  of bolt  (6) with  oil (E254).  Install  bolt and  washer (7) through  bracket  (3) and  bushing (1). 5. Install  washer (8)  and  nut  (9).  Torque  nut  to  155 inch-pounds. 6. Check  bolt  (6).  There  shall  be  0.10 to 0.17  inch of bolt  extending  through  nut (9).  Install  another washer (8) or  thinner washer,  if  needed. 6-46