TM  55-1520-240-23-5 6-14 REMOVE  FORWARD  DRIVE  SHAFT MOUNT (Continued) 6-14 Do  not allow  bolt  to  turn.  If  bolt turns, it  can  damage  bolt and  plates. NOTE Remove  left  or  right  mount  at  any  of six places  in  same  way.   Typical  right mount  is  shown  here. 1. Hold  head  of  one  bolt (1)  in  plates  (2).   Keep bolt  from  turning  and  remove  nut  (4)  and  special washer  (5).  Remove  bolt  and  special  washer  (6). 2. Rotate  plates (2)  to  align  hole  (7)  with  lower  of two  mounting  bolts (8). NOTE Reach  lower  bolt  on  drive  shaft mount through  bolt hole  in  plates.  Use socket and  extension. 3. Remove  nut  (9),  two  washers  (10), and  bolt  (8) from  top  and  bottom  of  mount (11).  Remove  thin washer  (12)  from  between  mount  and  support (13). 4. Rotate  plates  (2)  to  align  hole  (7)  with  mount bushing  (14). 5. Support  shaft (15)  with  cloths  (E120)  or  barrier material  (E80)  (16). NOTE Reach  center  bolt  on  mount  through bolt  hole  in  plates.   Use  socket  and extension. 6. Remove  nut  (17)  and  washer  (18)  from  bushing bolt  (19).   Remove  bolt  and  washer  (20). 6-43