TM  55-1520-240-23-5 6-13 INSPECT REMOVED DRIVE  SHAFT MOUNT AND  BUSHINGS 6-13 INITIAL  SETUP Applicable Configurations: All Tools: Micrometer Caliper  Set  GGG-C-105 Telescoping  Gage  Set  GGG-C-17,  Type  III, Class 2 Materials: None Personnel  Required: Medium  Helicopter Repairer References: TM  55-1520-240-23P Equipment  Condition: Off  Helicopter  Task 1. Check  mount  (1) for swollen  or torn  rubber  and unbending  of  rubber  from  metal.   There  shall be  no  swelling  or unbonding.  There  shall  be  no tears  more  than  0.25 inch  long. 2. Measure  diameter of  bushing  hole  (2)  in  mount (1).   Diameter  shall  not  be  more  than  0.441 inch.  Measure  outside  diameter of bushing  (3). Diameter shall not  be  less  than  0.432 inch. FOLLOW-ON MAINTENANCE: None END  OF  TASK 6-41