TM  55-1520-240-23-5 6-11 REPAIR  FORWARD  DRIVE  SHAFT (Continued) 6-11 NOTE Repair  all  drive  shafts in  the  same way.  A  typical  shaft  is  shown. 1. Remove  light  scratches, corrosion  and nicks from outside  edge  of  plates  (1). 2. Blend  out  nicks,  scratches  and  gouges  on  the face  of  plates (1)  with  abrasive  paper  (E15).  Do not  go  deeper  than  0.001 inch. 3. Blend  out  scratches,  nicks, and  gouges on  tube (2)  with  abrasive  paper  (E15).  Do  not go  deeper than  0.010 inch.   Keep  a  blend  radius  of  at least  1/2 inch.   Maximum  blend  area  is  0.80 square-inch. INSPECT Epoxy  primer  (E292  and  E293)  is flammable  and  toxic.   It  can  irritate skin  and  cause  burns.   Use  only  with adequate  ventilation,  away  from  heat or  open  frame.   Avoid  contact  with skin,  eyes,  or  clothing.   In  case  of contact, immediately flush skin  or  eyes with  water  for  at  least  15 minutes. Get medical  attention  for  eyes. 4. Touch  up  tube  (2)  as needed  with  epoxy primer (E292  or  E293). FOLLOW-ON  MAINTENANCE: Close  forward  drive  shaft  tunnel  access doors  (Task 2-2). END  OF  TASK 6-38