TM  55-1520-240-23-5 6-9 INSTALL COMBINING TRANSMISSION  FORWARD  ADAPTER ASSEMBLY (Continued) 6-9 Dry  cleaning  solvent  (E162)  is flammable  and  toxic.   If  can  irritate skin  and  cause  burns.   Use  only  in well-ventilated  area,  away  from  heat and  open  flame.   In  case  of  contact, immediately  flush  skin  or  eyes  with plenty of  water for at least  15 minutes. Get  medical  attention  for  eyes. 1. Clean  splines  of  adapter  assembly  (1),  retainer (2),  and  output  shaft  (3).   Use  dry  cleaning solvent  (E162)  and  cloths  (E120).  Wear  gloves (E186). 2. If  adapter  assembly  (1)  is  either  removed  or replaced,  align  drive  shafting  (Task  6-20). 3. Pack  splines  of  adapter  assembly  (1),  retainer (2),  and  output  shaft  (3)  with  grease  (E190.1). 4. Install  retainer  (2)  and  adapter  assembly  (1)  on output  shaft  (3).   Wipe  off  excess  grease  with cloths  (E120). 5. Coat  thread  of  retainer  (4)  with  grease  (E190.1). Install  retainer. 6. Place  wood  dowel  (5)  across  nuts  (6)  as  shown. Hold  dowel  to  keep  adapter  assembly  (1)  from turning.  Torque  retainer  to  825 inch-pounds. 7. Continue  tightening  retainer  (4)  to  align  holes in  retainer  (4)  and  adapter  assembly  (1).   Install lockring  (7).  Lockring  shall  protrude  at  least  0.06 inch through  adapter  assembly  (1). INSPECT FOLLOW-ON  MAINTENANCE: Install  No.  7  drive  shaft  (Task  6-19). Phase  rotary-wing  blades  (Task  6-28). Close  aft  pylon  lower  fairing  (Task  2-2). Close  aft  pylon  access  doors  (Task  2-2) END  OF  TASK 6-28