TM  55-1520-240-23-5 6-4 REMOVE  NO.  7  DRIVE  SHAFT (Continued) 6-4 NOTE All shafts  must be  rotated  as a  unit  to keep  blades  in  phase. 3. Rotate  shaft  (9)  to  position  two  bolt  holes  in adapter  assemblies (4  and  5)  at  top  of  shaft. 4. Support  shaft  (9)  with  cloths  (E120)  or  barrier material  (E80). 5. Remove  three  bolts  (8)  and  washers  (10)  from each  end  of  shaft  (9). 6. With  aid  of  helper  lift  shaft  (9)  from  between adapter  assemblies (4  and  5).  Remove  shaft. FOLLOW-ON  MAINTENANCE: None END  OF  TASK 6-20