TM  55-1520-240-23-5 6-4 REMOVE  NO. 7  DRIVE  SHAFT 6-4 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN  5180-00-323-4692 Materials: Barrier  Material  (E80) Cloths  (E120) Personnel  Required: Medium  Helicopter  Repairer  (2) Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power  Off Pylon  Hinged  Fairing  Open  (Task  2-2) Pylon  Lower  Fairing  Raised  (Task 2-2) Forward  Drive  Shaft  Tunnel  No.   6  Access  Cover Open  (Task  2-2) Remove  Cabin  Tunnel  Smoke  Baffle  (Task 2-170.1) Do  not  allow  bolts to  turn.  If  bolts turn, bolts and  adapter  assembly  can  be damaged. NOTE If more  than  one  bolt is  removed  from each  adapter  assembly,  assembly  will have  to  be  balanced. 1. Remove  one  nut (1), special washer  (2), and  bolt (3)  from  adapter  assemblies  (4  and  5).   During removal,  hold  head  of bolts with  wrench. Do  not  allow  bolts to  turn.  If  bolts turn, bolts and  plates can  be  damaged. 2. Remove  three  nuts  (6)  and  washers  (7)  from bolts (8)  at each  end  of shaft  (9).  During  removal, hold  head  of bolts with  wrench.  Do  not  remove bolts  at  this  time. 6-19