TM  55-1520-240-23-5 6-3 REMOVE  NO.  2 THRU  NO.  6 FORWARD DRIVE  SHAFT (Continued) 6-3 REMOVE  MOUNT BOLTS NOTE Remove  bolt from  mount at each  side of  adapter  assembly  in  same  way. Right  mount shown  here. All  shafts must  be  rotated  as a  unit  to keep  blades  in  phase. 3. Rotate  shaft (4) to  align  bolt  hole  (9) with  mount bushing  (10). 4. Support shaft (11)  with  pad  (12) of cloths (E120) or barrier material  (E80). 5. Remove  nut  (13) and  washer (14)  from  bushing bolt  (15).  Remove  bushing  bolt  and  washer  (9) through  bolt  hole  (9).  Use  socket  and  extension. REMOVE  SHAFT NOTE All  shafts must  be  rotated  as a  unit  to keep  blades  in  phase. 6. Rotate  shaft  (4)  to  position  two  bolt  holes  in adapter assemblies  (8) at  top  of shaft. 7. Remove  three  bolts (3) and  special washers  (17) from  each  end  of  shaft  (4). 8. With  aid  of  helper,  lift  shaft  (4) from  brackets (18).   Remove  shaft. 6-17